If you’re a tyre designer these days, you could be stuck between a rock and a hard place. Why? Because of EVs – more specifically, high-performance EVs. Tyres are a melting pot of compromise, trading off between grip, ride quality, wet handling, dry handling and rolling resistance.
Over the past decade, the significance of rolling resistance has been steadily increasing in line with the need to find that last percentage point of efficiency to reduce CO2 emissions. Suspension and tyres are closely matched during the development of a car and certain tyres are recommended for used on a particular model for that reason. An example is the Pirelli P Zero Elect, developed in conjunction with car manufacturers as a dedicated EV tyre.
One of the trickiest fitments was the Porsche Taycan, simply because achieving safe handling and roadholding in a high-performance car conflicts with low rolling resistance. An added challenge is designing a tyre that can support the extra weight of EV batteries without its construction being so stiff that it ruins ride quality.
Traditional tyre manufacturing methods of dealing with the higher loads of extra vehicle weight also make the tyre heavier, which in turn increases rolling resistance. And generating enough grip to harness the extreme, unrelenting torque developed by a powerful EV has to be balanced against rolling resistance and wear.
Road noise starts as vibration in the tyre, which is transmitted to the chassis, and Pirelli’s boffins say that understanding the physics of this particular phenomenon is crucial. The lion’s share of rolling resistance is caused by hysteresis: the tyre squashing as it rolls onto its contact patch and springs back as it rolls off it. Not all of the energy taken to squash the tyre is recovered: some is lost as heat, and that loss has to be made up by the car’s engine or electric motor.
Damping materials within a tyre’s construction soak up vibration and reduce road noise but also increase energy loss through hysteresis. To offset that, the P Zero Elect is designed to concentrate deformation in specific areas where there are fewer damping materials to reduce energy loss.
The way in which the compound is manufactured also has a profound effect on rolling resistance. New polymers and the way they chemically bond with fillers in the compound (particularly the silica in the P Zero Elect) influence the manufacturing.
The precise details of the manufacturing process are a closely guarded secret, but Pirelli isn’t worried about its technology being pinched by competitors. It may be possible to analyse the composition of the tyre, but without knowledge of the process, engineers are confident the characteristics of the finished material can’t be replicated.
They compare it to making fine Italian pizza: you can take fl our, water, salt and all the right ingredients, they say, but you still need the knowledge of how to prepare the dough, the process and the temperature of the oven to make a good one. Much the same is true when it comes to cooking up a high-performance EV tyre.
Go in with studs showing